Installation and Calibration

1.How to install the driver?
A. Please insert the 3.5inch floppy into your PC and open it.

B. Or you can download the driver from our website directly.

C. Running the “xbox.exe” setup program.

D. After running the setup program, you will see those dialog boxes as below shows, Click “next” to continue with the setup program, you can finished the installation.

E. Finally, press the finish button to exit this installation.

2.How to connect it?

A. Connect controller to our Products, and then plug our Products into your PC USB port.

B. PC will note you that there is found a new hardware, please do those steps to finish installation.

C. Click Next to continue.

D. Click “Continue Anyway” to continue.

E. Click Finish to close the wizard.

3.How to test it?

A. Then go into “My Computer”→“Control Panel”→“Game Controller”, you will see those dialog boxes as following:

B. Selected the controller which shows in control Box, then click “Properties” button, it will be go into the testing interface.

C. This page is special for testing the function of the controller button:

a. Testing button, when you press A,B,X,Y, Black button, White button, Start, Back on your controller, the relevant number will be light, just as 1,2,3,4,5,6,9,10 button on the testing interface.

b. Shake the left axis and right axis separately, the relevant “+” mark will remove with the frequent shaking.

c. The red spot in the “Hat Switch” box will remove while you press the direct key.

d. Test L,R VR button: If you press L VR button, the left box of interface will be filled with green color which will increase with deeper pressing until being full. Also if you press R VR button, the right box of interface will be filled with blue color which will increase with deeper pressing until being full.

D. To play different games, you can change the controller’s model as the arrow shows.

E. Change to “vibration” page to testing vibration.

a. Press “left” button on the “Force Test” box, the left motor of controller will be vibrated, you can got the effects time from the show bars.

b. Press “right” button on the “Force Test” box, the right motor of controller will be vibrated, you can got the effects time from the show bars.

c. Press “Dual” button on the “Force Test” box, then two motors of controller will be vibrated, you can got the effects time from the show bars.

Finally, press “OK” button to exit testing and calibration, then you can start the game.