V1.03
- Supports NEOGEO mini
1. Push the switch located on the left top corner of F300 Elite to the "DINPUT/PS3" mode. Push the switch "X/Y and DPAD" located on the left top corner of F300 Elite to the "DPAD" mode.
F300 Elite will be recognized by NEOGEO mini automatically.
2. If you connect the F300 Elite to your PC windows system, please press and hold "START" and "Y/△" for 3-5 seconds to switch to DINPUT mode.
3. F300 Elite will be recognized by PS3 as soon as you connect the F300 Elite to your PS3 system.
- Pressing and holding "select" and "START" works as "Capture" when you use the F300 Elite on Nintendo Switch system.
This manual describes how to update the firmware of MAYFLASH F300 Elite.
NOTE : The update must be done on a PC (Window OS); it cannot be done on a console individually .
NOTE : Make sure your PC is connected to the internet.
NOTE : Disable antivirus before executing the program.
Quick Start
Download the firmware from https://www.mayflash.com/Support and install it on your Windows system.
Double click on the firmware and leave the firmware window open on your screen.
Press and hold “HOME” button on the Arcade Stick F300 ELITE.
Connect the Arcade Stick F300 ELITE directly to a USB interface on your PC, still holding “HOME” button at entire time.
As soon as the updater window indicates under “Device” that the Arcade stcik F300 ELITE has been recognized, you may release “HOME” button.
select “update”
Do not disconnect the device until you are informed that the updated was completed successfully.
More Instructions
Download the firmware from https://www.mayflash.com/Support and install it on your Windows system
Press and hold “HOME”button on the Arcade Stick F300 ELITE. Plug the USB cable of F300 Elite in o your PC.
As soon as the updater window indicates under “Device” that the Arcade stcik F300 ELITE has been recognized, you may release “HOME” button. select “update”.
Noted:Do not disconnect or unplug the Joystick until the updated was completed successfully.
Press "OK" to complete the update.
