V1.06
Macro setup(Compatible Buttons include ↑, ↓, ←, →, ↖, ↗, ↙, ↘, A, B, X, Y, LB, RB, LT, RT, L3, R3)
Enable Macro Mode by pressing TURBO + MENU(OPTIONS) for 3 secs, Turbo LED blinking 2times/sec
（Noted: Press and hold TURBO first and then press MENU(OPTIONS)
To activate Macro by pressing Turbo+ VIEW(SHARE)
(Noted：Press and hold Turbo first and then press VIEW(SHARE))
For example here to setup Left, Right, A as a macro:
Enable Macro Mode by pressing TURBO + MENU(OPTIONS) for 3 secs(Turbo LED blinking 2times/sec)
Press Left, Right, A in turn
Exit Macro Mode by pressing Turbo button(Turbo LED back to the original status)
To activate Macro(Left, Right, A) by pressing and holding Turbo+ VIEW(SHARE)
(Noted: Press and hold Turbo first and then press VIEW(SHARE))
To set combos for other buttons, just repeat the above settings
* The Macro setting stays in memory for the next time
Button Remapping for A&B, X&Y, L3&R3
A=B, B=A; X=Y, Y=X by pressing and holding MENU(OPTIONS) + A simultaneously
Back to A=A, B=B, X=X, Y=Y by pressing and holding MENU(OPTIONS) + B simultaneously
L3=R3, R3=L3 by pressing and holding MENU(OPTIONS) + L3 simultaneously
Back to L3=L3, R3=R3 by pressing and holding MENU(OPTIONS) +R3 simultaneously
This manual describes how to update the firmware of MAYFLASH All-Button Arcade Controller F500 FLAT.
NOTE : The update must be done on a PC (Window OS); it cannot be done on a console individually .
NOTE : Make sure your PC is connected to the internet.
NOTE : Disable antivirus before executing the program.
Quick Start
Download the firmware from https://www.mayflash.com/Support and install it on your Windows system.
Double click on the firmware and leave the firmware window open on your screen.
Press and hold “Start" and "select” button on the Arcade Stick F500 FLAT.
Connect the Arcade Stick F500 FLAT directly to a USB interface on your PC,still holding “Start" and "select" button at entire time.
As soon as the updater window indicates under “Device” that the Arcade stcik F500 FLAT has been recognized, you may release “Start" and "select" button.
select “update”
Do not disconnect the device until you are informed that the updated was completed successfully.
More Instructions
Download the firmware from https://www.mayflash.com/Support and install it on your Windows system
Press and hold “Start" and "select" button on the Arcade Stick F500 FLAT. Plug the USB cable of F500 FLAT in o your PC.
As soon as the updater window indicates under “Device” that the Arcade stcik F500 ELITE has been recognized,you may release “Start" and "select" button. select “update”.
Noted:Do not disconnect or unplug the Joystick until the updated was completed successfully.
Press "OK" to complete the update.
